Beko Washing Machine Repair Costs

🔧
Ready to get your washing machine fixed?
Compare free quotes from up to 3 vetted local engineers. No obligation, no call-out fee to quote.
Get free quotes →

Beko occupies the budget-to-mid-range segment of the UK washing machine market, which means the economics of repair need careful consideration. The machines themselves are affordable (£250–£450 new), so repair only makes clear financial sense for lower-cost faults. Typical repair costs for a Beko are £70–£165 including parts and labour.

FaultTypical repair cost
Door seal replacement£75–£120
Carbon brush replacement£65–£100
Drain pump replacement£80–£135
Door lock replacement£70–£110
Heating element£75–£125
Drum bearings£95–£165
PCB / control board£110–£210

Common Beko Washing Machine Faults

Beko machines use brushed motors on most models in the standard range, so carbon brush wear is the most frequently seen fault — typically appearing after 4–7 years of heavy use. The symptom is a machine that fills and heats normally but will not spin, or stops mid-cycle. Brush replacement is inexpensive and absolutely worth doing on any Beko under about 7 years old.

Door seal splits are also common, particularly on older models where the rubber compound was less durable. A leaking seal should be repaired promptly — water reaching the motor or bearings turns a cheap repair into an expensive one.

Is a Beko Worth Repairing?

The answer depends heavily on age and fault type. For a Beko under 5 years old with a mechanical fault (brushes, seal, pump), repair is almost always worthwhile — the parts cost is low and you extend the machine's life at minimal cost. For a Beko over 7 years old with an expensive fault (bearings, PCB), the 50% rule often tips towards replacement: a bearing repair at £150 on a machine whose replacement cost is £300 is right at the threshold.

Parts Availability

Beko parts availability is generally good — the brand sells enormous volumes in the UK and parts are widely stocked by appliance spares suppliers. Most common parts can be sourced within 1–3 days. Older or discontinued model parts may take longer but are usually available.